1 Layer 3 s witch (Cisco 3650 with Cisco IOS Release 16.9.4 universal image or comparable).3 Router s (Cisco 4221 with Cisco IOS XE Release 16.9.If you are unsure, please contact your instructor.Īnswers N ote : Refer to the Answers Lab Manual for the procedures to initialize and reload devices. Note : Make sure that the routers and switches have been erased and have no startup configurations. Depending on the model and Cisco IOS version, the commands available and the output produced might vary from what is shown in th e labs. Other routers, Layer 3 switches, and Cisco IOS versions can be used.

The Layer 3 switch is a Cisco Catalyst 3650 with Cisco IOS XE Release 16.9.4 (universalk9 image). Note : The router s used with CCNP hands-on lab s are Cisco 4221 s with Cisco IOS XE Release 1 6.9.4 (universalk9 image).

Note: This lab is an exercise in configuring and verifying various implementations of DMVPN topologies and does not reflect networking best practices. This essential procedure will be covered in a later lab. Note: This lab does not include the configuration of IP s ec to secure the tunnels. In this lab, you will configure the IPv6 over IPv6 scenario. IPv6 over IPv6 – Both the transport and tunnel networks use IPv6.IPv6 over IPv4 – IPv6 is the tunnel protocol and IPv4 is the protocol that is used in the physical transport network.IPv4 over IPv6 – IPv4 is the protocol that is used on the tunnel and IPv6 is used in the physical transport network.IPv6 DMVPN can be implemented in three different address type scenarios: You will dynamically route overlay and transport networks over EIGRP for IPv6. In addition, the configuration process and the differences between hub and spoke configuration is also similar. Most of the tunnel an d NHRP commands have direct parallels in IPv6. In this lab you will configure IPv6 DMVPN Phase 3, which is very similar to the configuration with IPv4. Part 3: Configure EIGRP for IPv6 Background / Scenario

Part 1: Build the Network and Configure Basic Device Settings You will implement a DMVPN Phase 3 spoke -to-spoke topology using IPv6. In this lab, you will create a Dynamic Multipoint Virtual Private Network (DMVPN) that consists of a hub router with two spoke routers.

Dmvpn lab ccnp